5/7/2023 0 Comments Rotate image openofficeWhen satisfied release the mouse button.Click the mouse and move in the direction in which you want to rotate the graphic object. Move the mouse over one of the corner handles and the mouse cursor shape will change. Eight red handles replace the green square handles, as shown below.The Drawing toolbar is discussed in detail in Chapter 5. If the toolbar is not showing, select View > Toolbars > Drawing. This toolbar is usually located at the bottom the screen, but it can be undocked and used as a floating toolbar. Click the Rotate button on the Drawing toolbar.Select the graphic object if necessary so that the green handles around it show.To rotate a graphic manually, do as follows: To prevent accidental modifications of the size, make sure that the Size checkbox is selected in the Protect section in the bottom left part of the dialog.Īs for the position and the size, rotation of an object can be done manually or using a dedicated dialog. Notice that when the checkbox is selected both dimensions change simultaneously. To maintain the proportions between width and height, select the Keep ratio checkbox before modifying any value. Now modify either the Width value or the Height value of the object. The default setting (top left corner) means that the when resizing the area, the position of the top left corner of the area will not change. Select as the base point the part of the graphic object that you would like to anchor to the page. Be sure to release the mouse button before releasing the Shift key.įor more accurate resizing of the graphic object, use the Position and Size dialog. To retain the original proportions of the graphic, Shift+click one of the corner handles, then drag. The corner handles resize both the width and the height of the graphic object simultaneously, while the other four handles only resize one dimension at a time. Release the mouse button when satisfied with the new size.Click and drag to resize the graphic object.The pointer changes shape, giving a graphical representation of the direction of the resizing. Position the pointer over one of the green resizing handles.The unit of measurement for this and the other dialogs in this section is set in Tools > Options > Impress > General.įine adjustment of position and size of the graphic object. To prevent accidental modification of the position of the graphic object, select the Position checkbox in the Protect section (bottom left) of the dialog. The values represent the distance of the base point (selected on the right hand side of the dialog) relative to the top left corner of the slide. Use the Position section of the dialog to specify the X (horizontal) and Y (vertical) position of the graphic object. To open this dialog, first select the graphic object by clicking on it when the resizing green handles are displayed, either press F4 or select Format > Position and Size from the menu bar. Click and drag the graphic object to the desired position.įor a more accurate placement of the graphic object, use the Position and Size dialog shown below.On most operating systems, the cursor associated with moving objects is a four-headed arrow, but it may also be a hand or some other symbol. Move the pointer over the graphic object until the pointer changes shape.Click the graphic object, if necessary, to show the green resizing handles.Note that the same procedures can be applied equally to a picture (see Chapter 4) and to a graphic (see Chapter 5). This section describes the mechanisms that are available in Impress to move, resize and rotate a graphic object.
0 Comments
Leave a Reply. |